Questions & Answers for: Quantum slave

Slave Drive not recog in my computer but it is disk management with no drive letter I recentlt purchased a 80G hard drive which i tried to use as a slave in a Gateway desktop (the computer Os was ...

harddisk primary slave and cd rom secondary slave defferents and with diagram I know.... Go to www.informationpile.com for the solution to this problem...

hard drive quantum fireball lct 20 please i nedd to know how do i set up this hard drive as slave, i need to move the jumper to the coreect posicion. thank you I installed a 30 gig hard drive as ...

need a jumper diagram i need to know where the jumper is to be put on for master and slave quantum 30gig This is usually marked on the drive as a label and moulded onto the end cap. If this does not ...

hard drives im looking to set my maxtor quantum fireball AS 20.5-GB hard drive to the slave and i don't know what to set it on. what one should i set it on for the slave DS, CS, PK, or Rsvd. please ...

..."Jumper 50" is set; the two pins farthest from the power jack, is Master Drive. No pin jumper set, Slave or Cable Select. I hope this helps. I posted earlier for someone else, I hv an old quantum ...

cable ...if you have a normal ata /ide master ...just get it like it is ...but if you will set in a slave position you have to set the pin for it in the same manner ..... the default for the master is

how do i configure this hard drive for a 'slave' ? You need to set the drive as a slave by moving the jumpers the the correct pins. You should see 4 sets of pins, for slave you put the jumper over the

i have a maxtor quantum fireball plus as 20.5 hard drive. i want to set it to slave. how do i set the jumpers? on maxtor drives, you will find the jumper within a cluster of 9 pins. if you look on the

how do i set my drive to slave when the four jumpers are labeled DS, CS, PK, Rvsd? use the cable select pin option. as long as you have an operating system already installed and running , the cs ...