Question about 20.4GB 7200rpm ATA-100 HDD p/n 5T020H2 ATA-100 Hard Drive
slave pin settings trying to install maxtor as 2nd drive...need to change from master to slave on pin settings... hi frined remove your hard disk jumper & u r hard will be slave PLACETHE JUMPER IN THE
slave harddrive jumper settings i need to know what the jumper settings are for a Maxtor harddrive. I want to make it a slave in another system. I just need to know where the jumpers need to be placed
Question about Hard Drive
diamond max 20 hard drive won't install - jumper problems - want as slave, my old one as master don't know how to set pin. Want it to be slave drive. Not specific instructions, only on master & ata ...
need to make maxtor drive a slave drive is set up like this, :::.: The far left two r connected vertically. The next TOP two r connected horizontally. How do i set them so that this drive is slave? Hi
...I have 2 hardrive in my pc the 40 GB seagate as primary and the 30 GB Maxtor hard drive as a slave...My slave is detected on the BIOS but when im I open to the windows..it shows nothing.. What ...
Setting Maxtor HD as Slave. I have a Maxtor HD, Model (33073U4), that I like to setup as a slave. I am looking at the label on the HD and it does not give jumper combo to set it up as a slave. All it ...
Question about Hard Drive
Installing old maxtor HD on newr pc, have to change it to a slave Old maxtor hard drive 92720u8 from an old Hewlett P, manufatured 8/16/99, with no jumper diagram. I want this drive to be a slave on ...
i need jumper settings for maxtor n256 model 96147h6 i wish to run it as a slave pls help. thx For use as slave there is no jumper connected. (Master on/slave off0 The jumper settings are listed on ...
dimondmax22 stm3500320as 500MB juper setings for slave? During the boot process you will see on the screen to press a certain key to enter setup Press and hold that key during the boot up process to ...
setting maxtor 913804U to slave I have the manual but the first mention of jumper settings would indicate No Jumpers = Slave, but later in the manual there are diagrams which show 2 jumper positions ...
Usually answered in minutes!
772 Questions
421 Questions
140 Questions