Questions & Answers for: Asrock slave

Cannot get harddisk When I tried to Make two hard disk together(One Slave,One Master)the Mother B only detect the master ,sometime not(No IDE 1 detect)But always it canot get Slave..specially this ...

Cannot boot in Slave mode I cannot Boot to OS By making Any HD As Slave...The Mother Board Advice Make the HD Master..Why?In P3 Mother Board I Could boot From Slave HD,without Any Master HD..I Mean I ...

Befor New Mobo Kevin. replace your data cables and retry. else check your jumper settings to set as slave on the cdrw and master on the hdd

... if its on native it need a driver from floppy on xp cd boot . if its not detected in windowws as a slave. u need to run diskmgmt.msc and fin the unalocated drive and create part then format it ...

seagate harddrive diskread error my computer shows the following message when booting "disk read error press ctrl,alt,del to restart " .-i'm using windows xp drive is formatted in ntfs-i cannot repair

...when i set my hardisk as primary i was unable to boot into windows, unless i set the Hdisk into slave then i wont be able to enter windows. the problem is, if i set my hdisk to slave than it wont ...

...The options listed for 1st,2nd ,3rd Boot device include: IDE-0 means Pri master ? IDE-1 means Pri slave ? IDE-2 means Sec master ? IDE-3 means Sec slave ? 　　 single or master

...then SATA drives. I would suggest upgrading the motherboard. you need a ide only. set it to slave the second hard drive ok jim real

attached. A typical connection of 2 devices is 1 HD as Master and the second device (CD drive) as a Slave on a single cable. This leaves the second IDE open for expansion down the line. You could also

...(each port will take 2 devices) that the jumpers on the drives are correctly set to "Master", "Slave" or "Cable Select" as necessary, to ensure that both are recognised Hope this ...