signals turn signals not working lights ,brake, emergeny flasher all ok You may have installed a bed that has a different wiring configuration than the older style. The electrical systems are very ...
...system on could result in deployment of the air bag and possible personal injury. Disconnect the negative battery cable, and remove the steering wheel. Remove the bumper and the carrier snapring ...
...signal fuse is not blown,but melted in the fuse block.The battery voltage needs to be checked also.Check the charging system.it should be at about13.58 to 14.25.If the charging system is not at least ...
...you need to pull the stearing wheel and check switch. Looks like there is a short between the breaking system and the turn signal system. These both (Break and Turn) go through the switch. ...
...system uses a flat response 2-wire sensor. The sensor uses piezo-electric crystal technology that produces an AC voltage signal of varying amplitude and frequency based on the engine vibration, or ...
...System Check - Lighting Systems 2 Turn the ignition to the ON position. Place the turn signal switch to a turn left or a turn right position. Do the turn signal tamps flash ON and OFF? Go to Testing ...
system that most people are unaware even exists. From the moment you put your key in the ignition, there begins a constant line of communication between your key's security chip or transponder, to the
Question about 2006 Chevrolet Cobalt LS
...with a voltmeter ! Rather then just replacing parts. Is there battery voltage at the fuse ? Turn Signal Lamps The body control module (BCM) is responsible for controlling the turn signals and ...
Question about 2006 Chevrolet Cobalt LS
System Check - Lighting Systems 2 Verify that the turn signal lamps and/or indicators are inoperative. Do the turn signal lamps and/or indicators operate normally? YES - Go to Testing for Intermittent
Question about 2006 Chevrolet Cobalt LS
...System Description The BARO sensor has a 5-volt reference circuit, a low reference circuit, and a signal circuit. The control module supplies 5 volts to the BARO sensor on a 5-volt reference circuit, ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions