...dodge stratus. I get problem codes 1391,0352,1698,0340. Can you please tell me what these mean? 1391-loss cam and\or crank signal 0352-ign coil2 mal 1698-no etax ccd messages 0340-cam sensor signal ...
...where it comes over the rear of the engine chaffing at the valve cover causing the loss of the ...
...SIGNAL LOSS WHEN WIRING IS WIGGLED INTERMITTENT CKP SIGNAL LOSS WHEN WIRING IS WIGGLED IRREGULAR LAB SCOPE PATTERN OF CKP SIGNAL IRREGULAR LAB SCOPE PATTERN OF CMP SIGNAL CAMSHAFT POSITION SENSOR ...
...van no start Code P1391 Loss of crank or cam sensors,P0340 No cam signal at the pcm. I would replace the crank sensor first. Your cam sensor is part of the dist. on 5.2/5.9 engines. Hope that
...po 340 no camshaft position sensor signal at powertrain control module and code po344 rationality error detected for intermittent loss of camshaft position sensor circuit. hope this will help
...loss of either camshaft or crankshaft position sensor. check connections to both sensors. also look for any damage to the wires connected to each sensor. either sensor will set off a signal to pcm of ...
signal detected during cranking (bad Hall effect) OR timing belt skipped one or more teeth; OR loss of either camshaft or crankshaft position sensor. Can cause the engine to stop working entirely with
...loss of the timing belt. If no reference signal is seen during cranking after a battery disconnect, code 11 will remain. This is a helpful indicator in a no-start condition.Hope this helps and just ...
loss of brake lights tail lights work turn signal and hazards work new brake light switch still no brake lights Double check fuses, as well as power to switch at pedal, in and out.
Question about 2005 Durango
...to FM This may be due to the radio sensing a loss of satellite signal (a building, newer interstate freeway overpass, interference from microwave towers) and then the radio goes to another
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions