Questions & Answers for: signal board replacement Cars & Trucks

...board disconnected the left signal stops but no signals work at all.Any new suggestions appreciated. you have a short somewhere in the wiring. it could be a damaged earth and its using the earth for ...

signal relay. You will not like digging for it, because you will have to remove two peices of dash board, peice below instrument panel and knee board (2 bolts on bottom and 2 screws on top). The relay

...signal lights to stay on even with the car off. The relays are internal and located on the circuit board of the BCM. In order to fix you will have to remove and disassemble the bcm circuit board from ...

...signal works at a normal blinking rate. Any suggestions? the most common problem is the light boeard in the tail lights usually replace the board full of bulb sockets and that takes care of it but ...

signal clicks really fast. I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model.

signal works. Left turn signals are fine. The circuit boards in Chevrolet tail lamps ar notorious for going bad. Dorman makes a replacement circuit board, part number 70006 . the same part number will

...board that the bulbs sit in. If you remove the turn signal bulb. You will notice the bulb socket will be slightly burnt inside. I had the same problem with my 99 Denali and replaced the circuit board ...

...signal relay. The dash board light and turn signals work for an short time then the tail lights did not work. I have checked all the light bulbs and the wiring. I am stumped. Do you have any ...

...all bulbs and circuit board, still acts up replaced tail light circuit board and bulbs. the turn signal blinks 4 times and then blinks rapidly as if the bulbs are burned out ck turn signal

...signal to the other side? Probably replace the stalk with a new one. If you have an old car, the turn signals had relays under the dash board on the driver's side and they made the clicking sound. ...