Questions & Answers for: Kirby shampoo head

...head, then turn the knob to set the belt onto the motor spindle. Here is a very clear online instruction guide for the shampooer. Hope this helps!Marci ...

...shampoo upholstery do the following: remove bag from side of machine, place hose where bag goes, remove power head from front of the machine, place air intake valve on front of machine where power ...

...shampoo. No solution is coming back into the tray. try this shampooing guide http://reviews.ebay.com/KIRBY-CARPET-SHAMPOOER-INSTRUCTIONS-MANUAL-DIRECTIONS_W0QQugidZ10000000004594992 and make sure the ...

...shampoo as well)...I would suggest going slower when yours "laying down suds". And lower the shampooer head all the way to its lowest setting. I have found if there are a lot of oils in the carpet, ...

...shampoo head that will be in the owner?s manual, you remove the vacuum head and bag assm and attach the shampoo head, make sure you use genuine Kirby shampoo for the carpet. So if you need further ...

...shampoo the car carpets. Thanks Tanya The zippbrush and shampoer are two different attachments. The Zippbrush is a small hand held device that is basically a rotating cleaning head that attaches to ...

...suds after shampooing After dispensing the shampoo. You wait a few minutes. Then you turn 'off ' the shampoo picking the shampoo up. After the carpet is dry you pick up the rest. With the power

...shampoo head ALL THE WAY DOWN, unless your carpet is ultra thick and then maybe just one click up. Turn the dial on the shampoo mixing container to on. Push the machine forward rather quick and pull ...

...screw it on just as the bag screwed off. But make sure you attach the shampoo brush and attachment. Can't use the regular power head. The video is pretty helpful if you still have it. If not, try ...

...unless the shampoo tank, (or bag assembly) is fully installed. Be sure the tank is tight against the side of the machine, and not blocked by the cord, The shampoo head must also be fully