Questions & Answers for: Jeep Grand Cherokee shaft seal

Question about 2004 Grand Cherokee

2 Answers

...shaft seal leaks can be attributed to a worn bushing in the tail housing. I'd grasp the drive shaft and using an up and down motion, see if there is excessive play. If that's the case, you'll need a ...

Ad

Question about 1999 Grand Cherokee

1 Answer

...shaft or the seal retainer plate. once the bearing is off then you can slide off the old axle seal. now slide on a new axle seal, axle bearing, and bearing spacer. take assembly to a hydraulic press ...

Ad

Question about 2002 Grand Cherokee

1 Answer

...shaft, seal and bearing assembly Split the bearing retainer with a chisel and remove the retainer ring. Press the bearing off the axle shaft. Remove the axle seal and retaining plate. Fig. Rear axle ...

Question about 2004 Grand Cherokee

1 Answer

...shaft) then remove the seal and the outer race which will still be in the housing. next put it all back together, make sure the plate with the studs is still on then slide the seal, bearing, then ...

seal? There is nothing physically holding the TC on the shaft. Some just require more pulling than others to get loose. You can try turning left and right as you pull. The TC engages 2 sets of splines

...shaft seal be replaced without removing the timing cover? 2001 4.7 litre The answer is no. But if your that far into surgery why don't you replace water pump, timing chain,and cam shaft seal. ...

...SEAL ON THE SHAFT.ENSURE THE OPEN END OF THE SEAL FACES TOWARD THE AXLE SHAFT BEARING.PACK THE REPLACEMENT BEARING WITH WHEEL BEARING LUBRICANT AND POSITION ON THE AXLE SHAFT PRESS INTO PLACE.PRESS A ...

Question about 1999 Grand Cherokee

1 Answer

...seal to compensate for or the bearing that supports the shaft is worn. Other possibility is that the same tech is installing it dry every time he replaces it....you need to put grease on the seal lip ...

Question about 1995 Grand Cherokee

1 Answer

...out now, take out your bad oil seal, grease splines, then install new seal, carefully reinstall axle shaft to avoid damaging the seal, reverse steps and you're good to go. Good luck with your ...

Question about 1994 Grand Cherokee

2 Answers

...seal) tap in a flat method till the seal is seated. next remove the output shaft and the front seal to the transfer case. (there are 4, 8mm bolts) now just reverse the order and reinstall the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...