...timing 2.2 liter i bought a used amigo with a check engine light on. The scanner indicated cam shaft position sensor. I though i would check the timing before buying parts. Where should the ...
I cannot find the rubber seal for softtop I have a 93 amigo. I cannot find the formed hard rubber seal that fits between the softtop and the body. I have tried the aftermarket manufacturers as well as
...to be pressed on? No but they do have a snap ring that holds then in place plus the nut on the half shaft. You are going to need to replace the axles themselves because you won't likely be able to ...
How many quarts of power steering fluid does my 1993 Isuzu Amigo hold? POWER STEERING FLUID SYSTEM YOU POUR A LITTLE FLUID AT A TIME UNTIL FLUID LEVEL REACH THE COLD LEVEL MARK ON POWER STEERING DIP ...
...coming from front end. starts when vehicle is moving 35-40mph in four HI. I removed front propeller shaft, put it in 4x4, and no noise duplication. any suggestions on what it could be or further ...
Makes whining noise from windshield at or around 65 miles per hour. that means you have a bad seal and air is whistleing through that. Does it still do it with wipers on,make sure hood is closed all ...
I need a crank shaft for mi isuzu amigo98 2.2 please I need help. most auto pats stores can get a remain shaft for you could be cheaper in the long run to replace it with a used engine due to other ...
...when I put my clutch all the way to the floor this will be down to the thrust bearings on the crank shaft pushing the crank shaft against its webb's when the clutch is fully depressed would recomend ...
torqe spec for cam shaft 190 ft lbs
Question about 1998 Amigo
...mesher drive shaft seal touching area 4 mesher drive shaft Bush touching area this area damage want send machine Shoppe bush cover and drive shaft that time send seal also Damege change that Bush ...
Usually answered in minutes!
107 Questions
105 Questions
39 Questions
42 Questions
37 Questions