...axle housing that holds the 3/4 inch pin in place pull pin , push left axle shaft inwards and remove c clip from inside axle case,slide out axle shaft,remove seal,remove bearing and install in ...
Question about 1998 Sierra
...seal replacement how do you replace does the diff have to come out? Diff does not need to be removed to change axle. If you are good at this stuff, you can figure your way through it, or get a manual ...
shaft. the rear seal on the tail shaft must have gotten damaged when you removed the shaft. it is available at any good parts store, easy to change. you have to pull the drive shaft back out, then you
seal on the tail shaft of the transmission. I did that and now I have slowed the leak down but haven't completely stopped it. Now it leaves about a quarter size puddle overnight. Help! Hi!! Check that
...shaft until you can pull the seal. You might be able to do this without pulling the pulley or the crankshaft all the way. Clean where the old seal was and then put sealant and then the new seal in ...
1997 gmc 4x4 front axle leaking fluid pinion shaft seal
...part that goes after the seal? no there isn't but ck to make sure that there isn't any up and down play by pushing on the shaft at the rear of the trans if there is it could have a bushing worn
pinion shaft seal and bearing remove and replace Duplicate question.
Question about 1996 Sierra
...shaft, and the seal should be very visible there. Very fortunate, as this is the easiest and cheapest seal there is to replace! Be extremely careful installing the new one, if using a hammer or ...
...shaft . drill a small hole in the seal face and insert a self tapper screw in it . Use something like a slide hammer or a lever and pull the seal out . insert the new seal and tap into place hitting ...
Usually answered in minutes!
987 Questions
847 Questions
676 Questions
601 Questions
604 Questions