Questions & Answers for: GMC shaft seal

...clip holding the passenger axle shaft in place that you have to remove to change the seal. The drivers side axle stub can be removed with a little force as there is a spring clip holding that side

...tools to do so? The output shaft seal does not need to be replaced from the inside. You take a screwdriver put it on the lip of the output shaft seal and pound it out towards the back of the

...shaft) from the hub. Replace seal. It should pop right out. Good luck! neither of the previous solutions are coming from ppl who know what they are talking about. i am in the process of making this ...

...diff where the CV Shafts connect. Its on both sides on my 1997 GMC Sonoma. Is there a seal between the diff and the CV shaft or will the whole front axel have to be changed? There are seals. ...

shaft. the rear seal on the tail shaft must have gotten damaged when you removed the shaft. it is available at any good parts store, easy to change. you have to pull the drive shaft back out, then you

seal on the tail shaft of the transmission. I did that and now I have slowed the leak down but haven't completely stopped it. Now it leaves about a quarter size puddle overnight. Help! Hi!! Check that

...there and special tools i will need on this model. old models drop drive shaft remove carterkey from pinon nut take pinon nut off remove seal and replace. is the 04 assembled this way. thanks it ...

...crazy not knowing the problem I have run into the drive shaft seal and or dust cover drying out causing a squeal. Just pull the drive shaft and put a light coating of grease on the seal and dust

...to the shaft seal and bearings, but it would only be a temporary fix. Best option for this fault would be to replace the pump motor assembly. sounds like there is a crack in it. needs to be ...

...shaft seals? Remove the pitman arm, remove the lock ring in the steering sector, and then remove the washer and seal or seals (some units have 2 seals). Sometimes the old seals and washers are tough ...