...shaft seal, just above the bearings. If it leaks there, it suggests a faulty/mis-fitted seal, or that the shaft is worn after thousands of washes. Otherwise, refit the motor rotor and check that the ...
Question about Fisher & Paykel Washer
...seal is leaking and the bearings are run there will be rusty looking residue on the motor rotor(the round thing in the middle of the drum), seals and bearings are fairly expensive to replace About ...
...seal before shaft is damaged hope this has helped let me know The seals have gone, what happens is the neoprene seals breaks down and water penetrates the bearing, bypassing the armature while the ...
Question about IWL12 Top Load Washer
shaft seal. Turned on & all worked starting to fill then noticed water on floor as machine shutdown with no l I replaced the proportional cold water inlet valve but stuipidly I forgot to fit the valve
Question about IWL12 Top Load Washer
...replaced the proportional cold water inlet valve but stuipidly I forgot to fit the valve shaft seal. Turned on & all worked starting to fill then not Model MW058U Go back and fit the valve shaft
Question about IWL12 Top Load Washer
seal's surface which comes in contact with the shaft. To replace the shaft you will need a hydraulic press to press the shaft out, as well as a good quality bearing puller. For these reasons
Question about IWL12 Top Load Washer
...on the bottom of the rotating tub. I cant see where I can tak Top loader, 7.5kg Is it loud on spin cycle, It will need a seal & bearing kit may also need a shaft (deep grooves on shaft from
Question about GWL11 Top Load Washer
...shaft seal and bearings.Now the shaft with the wash bowl attached slides down through the seal,top bearing, spacer and lower bearing causing the motor to The washing machine start and runs until the ...
...the main seal and shaft, it can be quite costly. if its a front loader you will need the main seal and both bearings and will cost twice as much as the top loader as it takes quite alot longer to ...
Question about GWL11 Top Load Washer
...seal in GW 612 fisher and paykel washing machine and now wont spin and lid doesnt lock if the bowl is stilf to turn when stator cover is off by hand, remove agitator give the end of the shaft a hit ...
Usually answered in minutes!
1,514 Questions
200 Questions
88 Questions
87 Questions
45 Questions