Questions & Answers for: shaft removal

...from housing cover area. Loosen housing cover bolts. Drain lubricant from the housing and axle shaft tubes. Remove housing cover. Rotate differential case so that pinion mate gear shaft lock ...

Ad

...Shaft Removal Raise and support the vehicle. For additional information, refer to Section 100-02 . Remove the wheel and tire assembly. For additional information, refer to Section 204-04 . Remove the ...

Ad

Question about 1999 Town Car

1 Answer

Shaft Removal Disconnect the battery ground cable (14301). Remove the windshield wiper pivot arms (17527). Remove the nuts (one each side). Remove the windshield wiper pivot arms. Remove the LH and RH

Question about 2001 Corvette

1 Answer

Removal and Installation. 3. Remove the stabilizer shaft link nuts from the stabilizer shaft. 4. Remove the stabilizer shaft insulator clamps from the front crossmember. 5. Remove the stabilizer shaft

Question about 2001 Corvette

2 Answers

...support caliper with wire. Remove seal retainer nuts from axle housing. 2 . Pull out the axle shaft from housing. Remove the snap ring and bearing race from the axle shaft. Cut the bearing ...

...Removal Raise vehicle and place jackstands under rear frame crossmember. Lower the hoist so that rear axle housing is at suitable working height. Remove axle housing cover from rear axle housing and ...

Question about 1999 Econoline

2 Answers

...Removal Raise and support the vehicle. Remove the wheel and tire assembly. Remove the differential housing cover and drain the lubricant. Remove the rear brake drums. Remove the differential pinion ...

Question about 1999 Econoline

1 Answer

...Shaft Removal CAUTION: Do not use heat to loosen a seized lug nut. Heat can damage the wheel (1007) and the rear wheel bearings (1225). Loosen the lug nuts (1012). Remove the center cap. With the ...

Question about 2003 Baja

1 Answer

...removal steps.Note: Take care when re-installing drive shaft to gearbox output shaft. This will usually only align to a single position. Before tapping retaining pin back into place, ...

...Removal and Installation. Remove the brake caliper. Refer to Rear Brake Caliper Replacement. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement. Remove the rear axle ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...