...sewing machine..i start to sew and the needle comes unthreaded all the time,with even one stitch, won't even let me sew anything..its the kind sits ont he table,,no name on the sewing machine ,,its a ...
wheel was still stuck. So I checked the belt between the handwheel and the motor. I tugged on it (while the machine is off) and tugged on the belt to turn the handwheel. It took a couple tuggs to make
Question about T111155 Mechanical Sewing Machine
how to thread machine the tacsew t111155 sewing machine how to thread this machine contact tacsew or a dealer about threading instructions
Is there a way to slow down the motor on a Tacsew blindhemmer machie want to slow down the motor someway for better control. the motor is under the table the machine sits on and is connected by a ...
wheel. Thought the machine just needed to be oiled, but that hasn't fixed the problem. Then I tried turning the pulley wheel manually and found that the machine turns freely for two cycles but
Manual for Tacsew GC6-6 American Sewing com Discount Sewing Machines Supplies
Question about T500
I can't get the stitch close to the hem. Normally i would tighten the tension but when I do this for this project (thicker than normal) the thread comes out of the tension wheel. change position of ...
...machine jamed it is jamed and I can't get the wheel to turn either way it turnes just about an1/8th inch and no more Sounds like a thread jam ! Open bobbin case housing remove bobbin and clean away ...
...wheel stopped and it won't move now. Can it be fix or can I do it myself? Thank you sounds like the spool case is jammed up take the spool case out check the drive belt is ok in some you just need to ...
Question about 20U43 Sewing Machine
sewing machine. The needle broke - so I replaced it. Now the machine will not sew.I noticed the belt on the wheel is not moving. what should I do Have you tried cleaning under the bobbin case and feed
Usually answered in minutes!
33 Questions
11 Questions
6 Questions
5 Questions
13 Questions