apparently valve not working, how can I check it? Radiator nor warming up whatever setting. There is no air lock. sounds as though the thermostatic radiator valve is stuck although the valve settings ...
...set #5 valves, turn the engine till #6 valves rock, set # 3 valves, turn the engine until #3 valves rock, set # 6 valves, turn engine till #5 valves rock, set # 2 valves, turn engine till #1 valves ...
...set the air gap between the flywheel and the ignition unit which should be around 0.25mm (0.010") Excessive air gap will retard the ignition timing. Unless you've had the engine apart, the valve ...
Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1
setting specs for 1996 geo tracker 16valve valve lash need to know the spec settings for valve adjustment. 1996 geo tracker 16 valve .008 to .009 factory set ,i set mine at .007
Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1
...set by either cutting out valve seats with a special cutter tool (to DECREASE clearances) or grinding the end of the valve (to INCREASE clearances) and generally are from .008-.010 on intake valves ...
Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1
intake and exhaust valve settings i want the intake and the exhaust valve valve settings for this engine ? . it is a valve in block motor or what you may call a side valve motor You have not indicated
Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1
set valves on both sides of twin engine.mower wont start.take spark plug out on right side engine starts when setting gaps make you go toward the high end not low. if too low the valves will not close
Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1
...are other problems. Does the valve only leak when hot water is called for? Then check temperature setting on heater. Does it lek all the time? The water pressure is to high , Maximum Temperature ...
Question about 1989 - 1995 Geo Tracker Engine Valve Stem Seal Set SS 72675-1
...set 2013 Hyundai H100 valves clearance. Hyundai H100 2.6 diesel bakkie is: Intake valve clearance: 0.25 - 0.35 mm (0.010 - 0.014 in) Exhaust valve clearance: 0.45 - 0.55 mm (0.018 - 0.022 in) ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions