Questions & Answers for: Ford Ranger how do i set my valves

...valves should be fully closed on the # 1 plug if it is your timing should be right if one is slightly open then tuen it till the #1 valve is closed and the gear marks line up then slide the belt back ...

**** in air. Repeat until the stream is solid. Refill the clutch reservoir with Dot3 fluid and your set to go

what are the settings for valve gaps on a x reg ford ranger (uk) 2.5 non-turbo dieseal engine? This is not a solution, but maybe a suggestion and please don't vote me bad, but here in the Us there ...

2008 ford ranger heater only blows hot no adjustment and ac is hot on regular setting and cold on max. 08 Ford Ranger 4.0 same problem but it is vacum not electric no vacum on hose in cold or hot ...

...valves. The valve operates off of vacuum and the problem may just be a torn or disconnected vacuum hose. However if the valve is clogged it will need ro be removed, cleaned, inspected and reinstalled ...

my 02 ford ranger has no heat.I changes the thermostat and had coolant was flushed everything looks good. It is like the AC is workking on both AC setting and Heat setting. Every machenic i have spoke

...torquing bolts to appx. 72-108 inlb. Replace pvc vacuum line followed by plug wires and you're set. This is a stripped down version as there will be many hoses and lines in the way but you

looking for the valve (tappet) settings on my 1999 2.5D 2WD ford ranger (non Turbo) Hi Tom Valve clearance INLET 0,05 - 0.15 MM COLD EXHAUST 0,15 - 0.25 MM COLD

...use starter fluid and every time after that on its own. even if i drop the fuel pressure and let it set for an hour or so it still starts right up. could an idle air bypass valve cause this? If your ...

how to adjust tappet clearaNCE OF FORD RANGER 12 VALVE Unless the is a modified engine, there is no setting on the valve clearance. It has hydraulic valve lifters and they don't require any setting of