Question about Franklin Brass Towel Bar Brass 18
...mounting bracket, and is made secure by a set screw. I don't mind buying a set of brackets, but I only need one call this number 800-542-3789 perhaps they have your part or know where you can get ...
Question about YB2818 Eva Towel Bar Bathroom Accessory - Brushed Nickel
...set screw) on the bottom section of the towle bar bracket. I was told by Moen to insert the flat head screw driver and depress a spring clip and then pull the bracket from the wall. However this does ...
set screw visible. We did not install them. Newer towel bars don't have set screws... Solution-slide off! There is an opening in the bottom of the bracket. Slide your flat head screw driver inside
Question about YB8086 Mason Towel Ring Bathroom Accessory Chrome
...set-screw" (a very small screw) at the bottom of base (fat part) of the towel bar. It screws in to hold the fat part of the bar to the "tab". Loosen the screw by turning it counter-clock-wise. Once ...
Question about YB2818 Eva Towel Bar Bathroom Accessory - Brushed Nickel
set screws but appears to have some type of slot/clip arrangement. it is a brushed nickel 18 inch bar. The only one I can find that fits this description is YB2218BN. I have tried pushing the clip and
...set screw on the flange cover? I think you grab hold of the rosette closest to the wall and spin it off, it should expose the set screw. If that isn't it, one of those things will turn. Try a few ...
...set of mounts go with which pieces. The toilet paper holder is to be mounted onto our wooden vanity. I'm assuming the black mounting brackets will use standard screws to hold the brackets in place, ...
Question about YB2818 Eva Towel Bar Bathroom Accessory - Brushed Nickel
...you remove the eva towel rack holder The Moen YB2824 is attached to the mounting bracket with a set screw through the base. You would simply need to loosen this set screw to remove item from the
Question about YB2218BN: Brantford 18 in. Towel Bar in Brushed Nickel
...set or trying to figure out some way to work around the gaping hole the defective mount left in my wall and use the existing one (which I don't see happening as the strength of the wall is already ...
Question about 24 In. Towel Bar...
...set screw There is no screw here. Insert a small flat screwdriver -- small enough to fit fully in the hole -- and pivit it up, so that the tip presses toward the wall. This should easily release the ...
Usually answered in minutes!
350 Questions
260 Questions
250 Questions
168 Questions
217 Questions