Questions & Answers for: how to set room temp

...set point ("ST" on the unit) (say 75 degrees), my heater will run if the room temp ("RT" on the unit) is lower than 75 degrees. However, after the heater runs and reaches 75 degrees, the "RT" will ...

...room. What is wrong with it, Termistat or compressor? Try to set the thermostat to higher temperature and monitor if the compressor will turn " off " when the room temp. is cool, and turn " on " when ...

...it runs forever and the room temp is 72F. Set at 79F, it runs, room temp shows 73 F, sometimes 75F or 77F. The Ac is on then off every 5 minutes even the desired temp (is set) reached. Lousy

keep it set on 60 and the room stays at 74. We'd like the room to be 68-70, but 60 is the lowest setting on the heater. I don't think our model has the external room sensor, so I don't know what to do

...room temp reads 77, I set the AC to 75 and the AC runs. The room gets cooler but the temp on the thermostat now reads 80. Its not 80 in the room, but that's what the thermostat reads. If I turn off ...

... The set point is different from room temp. My tsat show set point and room temp. But to answer you when you set at 72 and room temp is 75 . It will go back to room temp till you reach that temp. ...

room and the set temp is being read from the thermostat or is there another thermometer in the room your looking at Is there a setting on your thermostat that makes the unit stay on for 10, 15, 20, 25

...set at 76 shows room and setting the same all the time shouldn't the room temp rise before unit comes on. Yes the temp should rise 2 to 3 degrees before the unit comes on, This is called the temp ...

...room temp. In other words if we set the remote temp to, say, 75 degrees, the room will only heat to 65 to 68 before the unit stops heating. Leaving it set like this maintains and even temp over many ...

...Installation Manual. Pages: 0 FREE-TO-DOWNLOAD HAIR CONDITIONER MANUALS https://www.manualslib.com/brand/haier/air-conditioner.html Likely displaying the room temp rather than your set point