Questions & Answers for: Chevrolet S 10 set number rings pickup

Question about 1997 S-10 Pickup

1 Answer

...pickup with anti lock brakes and I just changed the two front rotors and I made sure that the new rotors were for anti lock brakes, but now my anti lock brake light stays on in the dash and the anti ...

Ad

Question about 1999 S-10 Pickup

1 Answer

Fuel Pressure Regulator Where is the fuel pressure regulator located on a 1999 S10 chevy pick-up?? not sure on an s10 but it should be close to the same position as a full size truck. Should be in the

Ad

can a 1988 chevy S10 2.5l ecm be used in a 1987 chevy S10 2.5l the numbers on the ecm must be the same . you have 2 sets of numbers and the bottom set should be the same.

1987 chevy s10 need fule injector replacement. I have removed the injector but the o ring inside was damaged and there was only 1/2 of the o ring there. Is there any reason to worry about the missing ...

Question about 1996 S-10 Pickup

2 Answers

rings, how can I test to see if its valves. And is it a common problem with S10 4.3 vortec motors? Leak down tester, swap the spark plug for the tester, have the motor set where both valves are closed

my chevy s10 leak oil when park around a plug that 2 wirer go to on the side of the transmission That would be the neutral safety switch and it should have an O-ring to seal it. The O-ring may be bad.

...rings it appears to have set pins or some thing holding them in is there a special trick to removing them ? There glued in you need to heat em up to remove em, or stick em in a vise and beat the h*** ...

which way does the themosat gasket go on a 1997 chevy s10 2.2 ThermostatIf It's an O-ring it will go on either way and seal the thermostatic gasket.Removal & Installation2.2L EngineTo Remove: ...

Question about 1999 S-10 Pickup

1 Answer

have 1999 s-10 2.2 liter. has gas in the oil, gas coming out the tail pipe, shakes badly, and has very strong fuel odor. Might be a frozen (stuck) piston ring, or bad exhaust valve. To narrow the ...

...number 4 because it carboned up and all the others aren't I had same problem and turned out mine had bad o rings on the injector. I could hear air being sucked in until i put my finger near it. Might ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...