Question about 3/4hp Super Pump Inground Pool Pump 115/230 Volt # Sp2605x7
...pump motor i have a new motor but i cant seperate the pump on the motor armitur i was having the same problem with my pool motor, and couldn't saparate so i replace it as unit both pump and
Question about 1.5 Hp Northstar High Performance Pump
with an allen wrench. Seperate pump housing from motor remove the old seal replace seal. Lube motor shaft with a little clean oil or wd40 to facilitate easy install thru new seal,reassemble in reverse
Question about 1.5 Hp Northstar High Performance Pump
...motor when the machine is turn on. kenmore built-in dishwasher model #665 leaks above the motor The seal around the pump / motor assembly may be bad. The seal can be purchased seperate from the
...seperate pump and motor for drain could have somthing in it if the pump is driven by the main motor pump could have frozen up or motor could be bad in spin mode sometimes the timer won't make the ...
...the motor need to be replaced? Try supplying a seperate 12 volt power supply to the positive lead to the fluid pump motor. If it works, it is the switch, but if it does not work, it is the pump
Question about 1.5hp Pool Pump Motor Motor A O Smith Electric Pool Motor for 56j Frame Motors Ust1152
...pump but cant figure out how to seperate impeller from motor Might be a screw in middle of impeller with reverse thread. If so, remove. Remove back cover of motor, hold center shaft with wrench and ...
...wrong with the pump. if it's motor, do you know any place online that i can order it? thank you. The pump and motor comes as one unit. Motor does not come seperate. Pump parts can be sold ...
seperate the pump from the impeller housing to replace all internal gaskets, How do i seperate the motor from the impeller housing THERE IS THE TANK GASKET THE DIFFUSER O-RING,LID O-RING AND THE SHAFT
Question about 2 hp WhisperFlo InGround Pool Pump WFE28 ()
...pump. Others, however have journal either one piece to motor shaft or journal is pressed on. If you do not see bolt thru journal, most likely it will not seperate. Check with parts manual for more ...
...pump. It appears the motor should now just slide out the back, but despite wiggling, pulling, etc., it won't let go. You didnt mention removing the impeller before trying to "slide it out" Remove the ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions