Questions & Answers for: sentra control module

...sentra, shut off at traffic light and will crank but will not start. changed out both crank and camshaft sensors but still no luck. There is no spark to the spark plugs. What can be the problem? The ...

...the new 2008 nissan sentra has and where they are located? There is 1 ecm(electronic control module), 1 tcm(transmission control module), and a few other control units. The ecm is in the engine

...Sentra GXE. The head gasket was just replaced. Now, when the ignition is in the off position, the power won't turn off. Tried replacing ignition switch, but that wasn't it. Ideas? look on the back of ...

where is the transmission control module located i... Where is the transmission control module located in a 2000 nissan sentra ? where is the transmition control module in galant 2000

...Control Module I can't find the ECM under the hood of my Sentra. I want to replace the defective unit with a used ECM from the scrapyard. Why would a 6 year old vehicle need a new ECM? If you can't ...

how do you replace the ignition control module on a 93 nissan sentra under the rotor inside the dist cap??

SENTRA SERVICE ENGINE LIGHT CAME ON ; ANYLIS DISPLAYED CODE P1320. HOW DO I FIX IT? check engine light on means some fault codes stored in your engine control module.use this tool clear the fault code

...on 2012 nissan sentra passing gear quits working. If i pull over and stop for a little bit it starts working again. You need to have the fault codes read in the transmission control module

...Sentra Description Swirl control valve position sensor is installed on the intake manifold.
The sensor is connected to the front end of the valve shaft of the swirl control valve.
The sensor ...

sentra 1.8l when car is idleling the motor races up and down how can I fix it This could be a few things like low fuel pressure, vacuum leaks and even the engine control module. I would start with the