2001 grand cherokee and couldn't get it running. it was towed to my shop and it didn't have a crank sensor in it. i put one in and it started however the rpms go up to 5000 when starting. replaced the
needs to find out where the map sensor is located? in air intake duct after air filter box
not current in the fuel pump and check the fuse and nothing that I review or should I look to find the error do you have spark? it's sounding like the crankshaft position sensor might be bad if it don
...INTAKE MANIFOLD MAP STANDS FOR MANIFOLD ABSOLITE PRESSURE THE SERVICE CODE SHOULD BE PO1106 HIGH VOLTAGE OR PO1107 LOW VOLTAGE IF YOU DON;T HAVE THESE CODES THEN ITS PROBELY NOT THE MAP SENSOR ...
2001 jeep grand cherokee laredo overheating. replaced fan relay and thermostat, and its still overheating suggest that you rent a pressure tester from auto zone or advance auto and preform a pressure ...
intake manifold sensor You should be more specific. There is an intake temperature sensor and an intake manifold pressure sensor (MAP)
Question about 2001 Grand Cherokee
2001 jeep grand cherokee. The voltage from the tps plug was 1.5v exhaust is broke off at the muffler. I replaced the crankshaft position sensor and the vss when it showed p0725 and p0731. now it shows
what does code PO108 mean ? dio. read PO108 MAP/DARO curcuirt high input and how can I fix it myself Hi Debbie, The code P0108 refers to the manifold pressure sensor which reacts to the low pressure ...
...2001 see emission chapter, see diagnostics, see 1291? says intake air temp sensor reads wrong, its easy to test first makesure its plugged in and wires not damaged> ...
Question about 2001 Grand Cherokee
Where is the map sensor located on a 2001 Jeep Grand Cherokee limited 4.7 it is on the front of the upper intake manifold, behind and off to the left of the alternator. This is for the 4.7, God-Bless!
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions