Questions & Answers for: Subaru Legacy sensor po325

...and it bogs down and the light comes on i took the car to auto zone and they said it was the knock sensor but that does not sound right since the car loses its go when the engin light comes on i was ...

...PO325 knock sensor code. Resistance was out out range and replaced the sensor. The resistance on the coil reads good but I haven't seen it on the scope. I don't have a scope to see and read the ...

Knock sensor 1999 Legacy 2.2 Where is knock sensor location on engine is there more than 1 As far as there being no knock sensor on a 99 2.2 I beg to differ. I have a 99 legacy and just had a ...

I need to change the knock sensor on my 1998 Subaru Legacy. I've ordered the part, just need to know where to find instructions on changing this sensor and where exactly it is located on the engine. ...

throttle position switch. how much for the part? is it easy to repllace? This sensor sends the ECU an output signal which corresponds to the opening of the throttle valve. Using this output signal, ...

...rpms drop after revving. I analyzed the codes and it is telling me there are 8 errors! Crank angle sensor (no sig) cam angle sensor (no sig) water temp sensor (abnormal signal emitted) air flow ...

...sensor is working.i have a 99 legacy outback i just bought and i have a po325 code i also have a toyato pickup with s3.0 which gave that code constantly until i changed the timing belt a 92,000 miles ...

...3.0 R B Spec only covered 25,000 miles from new and the EML light has come on due to the knock sensor throwing a fault, also the Cruise control light is flashing on/off and inoperable, also the ...

crank sensor fuse put new moter in car with a new crank sensor car is throwing a code for crank sensor crank sensor need to be set with diag tool for learning .

how to test a abs sensor I fixed wires going to sensor but light stilll on dash . Can I test the rear ABS speed sensor to see if it is connected Here's a youtube link that you can use to test the ABS ...