...does not work you will need to take it in. May be a bad sensor or unpulged but that is rare. Also not all bernina feed have this foot sensor, if this is the case it will not read it hope this ...
foot with the sensor lenses on it ... your machine has the optical sensor for the automatic buttonhole foot and I'm wondering if you're getting it confused by using a foot that is not designed
...sensor one-step buttonhole foot husqvarna sewing machine won't sew because it says remove sensor one-step buttonhole foot and that foot is not on Sounds like the sensor has gone bag or something is ...
...sensor, plugs and wires, cap. And rotor Check the vacuum hoses for a leak. Engine dies if I dont keep foot on the gas - AnandTech Forums forums.anandtech.com > Social > The Garage AnandTech Jun 23, ...
Question about 1008
...foot. Sometimes the sensor has a smudge or lint on it that is disrupting the sensor. You might try cleaning it. If it doesn't occur with any other foot, then it is probably an issue with the foot ...
Question about 1008
...buttonhole foot connected. Please remove foot" while I am sewing with a regular foot and a regular straight stitch. It sounds like the sensor connection where you plug in the buttonhole foot is
Question about 1008
...foot that has a sensor on it. Make sure you are using a presser foot made for your machine. Yes what R.A Ellis said dear. More than likely that will slove yr problem. You must use all the same ...
Question about 1008
...not be necessary basically your foot position on the pedal is the position sensor calibration and by moving the foot that calibration alters so the throttle body sensor reacts to that new ...
Question about 1008
...as you put your foot on the gas it drops to 5 or 10 mph.. I changed all 3 speed sensors???? Test the alternator. A bad diode within the alternator can have some crazy ripple effects on sensor
Question about 1008
...sensor (also called the foot controller) is not, there are a few things you can try: Check the connection: Make sure the foot controller is properly plugged into the machine. If it is loose or not ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions