Question about 1996 Tacoma
96 tacoma failed inspection because O2 sensor was ''missing bolt'' My 96 tacoma just failed a state safety inspection because the O2 sensor was ''missing bolt,'' as it states on the report. I replaced
toyota tacoma 2001 failed to crank, got obd II code p1133(air fuel sensor circuit response malfunction) where is located AIR FUEL SENSOR IT IS LOCATED ON THE EXHAUST MANIFOLD.IT LOOKS LIKE OXYGEN ...
...fail often. This code is for the crankshaft sensor failure, odds are this is an early warning of the crank sensor failing. You can see one, and buy one at the link posted below. ...
...my 2001 tacoma v6 what is the problem p0141 indicates that the heater in the upstream (#1) oxygen sensor has failed. It will take longer for the O2 sensor to heat up, taking longer for the computer ...
Question about 1999 Tacoma PreRunner
...misfiring at random. both upper plentun gaskets, spark plugs injectors, catalitic convertor and o2 sensors have been replaced. found the timing off 1 tooth, retimed engine stil runs poorly. any
Question about 1997 Tacoma
1997 tacoma 2.7 cam sensor problem replaced it but still code p0340 so tryed crank sensor i got code p0340 cam sensore so i replaced it and truck trys to run but dies so i tryed crank sensore same ...
p0171 code bank 1 lean-is this an 02 sensor? A code P0171 may mean that one or more of the following has happened: The MAF (Mass Air Flow) Sensor is dirty or faulty Note: The use of "oiled" air ...
p0171 bank 1 lean- is this a maf or o2 sensor? could be several problems: MAF could be dirty or faulty exhaust leak between engine and first o2 sensor low fuel pressure or sticking/plugged fuel ...
Question about 2002 Tacoma
misfire 02 Tacoma 2.7 replaced all coil packs, plugs and fuel to air sensor and still have miss Timing Belt worn & jumped? Replaced parts with no testing at all? No looking at scan tool data or ...
Question about 2002 Tacoma
i got a po136 code when i change the exhaust box can it be the o2 sensor or the exhaust This code indicates the downstream o2 sensor has failed. Make sure there are no exhaust leaks near the sensor ...
Usually answered in minutes!
352 Questions
307 Questions
394 Questions
295 Questions
304 Questions