water pump replaced the water pump in the cutlas.. now upon acceleration the car squeels and screams... any idea what else is wrong sounds like you have a fan belt loose or misaligned That sounds like
my turn signals come on but want flash. Where's my turn signals come on but want flash. Where's the flasher unit on a 1994 cutlass supreme? Front seating area, driver side, under dash, mounted on ...
96 Corvette Bearings Hi there, Would you be able to summarize the process for taking off the old and putting on the new bearings for a 96 Corvette? Is it one bearing mechanism and can it be done in a ...
CAN YOU GET TO THE FUEL PUMP ON A 1993 OLDSMOBILE CUTLASS 3.1 FROM THE BACK SEAT OR DO YOU HAVE TO DROP THE GAS TANK TO GET TO IT? Not sure what model of Cutlass you have but if you know you don't ...
...ventilated area. Disconnect the negative battery cable. Relieve the fuel pressure. Remove the rear seat cushion. Remove the floor service hole cover. Disconnect the electrical fuel pump wiring at
...brake fluid. Apply approximately 778 N (175 lbs.) of force to the brake pedal 3 times in order to seat the pads. Burnish the pads and the
What is the bracket called that hold both the alternator and the air compressor on a 1984 olsmobile cutlass supreme 3.8 V6 it's one whole bracket Engine accessory bracket.
...that is broken but may be missing. The brackets on the floor should have a U shaped hook to them, the metal loops on the seat fit into the brackets and the pressure od the seat holds them in
detailed drawing of the power steering assembly and brackets If you need detailed specs, then you need to find an old body shop that's been here for ages. They might have your specs. A good ...
Question about 1988 Cutlass
How to change the power steering belt on a 88 Oldsmobile cuttlass with the 307 engine in it If I remember correctly, you have to take the alternator and A/C belt off in order to get to the power ...
Usually answered in minutes!
319 Questions
282 Questions
8 Questions
6 Questions
1 Questions