...seat can be split! I am looking for '01 -02 LT or SLT center row buckets, if they will fit the floor brackets - my dealer cannot determine if the attachment is workable! (Someone, please help) These ...
...of my 2004 impala there are two brackets..one located in the middle of LhH seat and same for RH side. push in on the front of the seat and pull up. it does usually take some preesure to push and
...seat. They directed me to the police station across the road because they said they couldn't just put the anchors in & that the police would know where to put the anchors. The police station ...
how to install a car seat in a 1999 chevy cavalier You must try and pop a clip off of the rod sticking out of the passenger side seat where the hinge bracket is. Once the clip is removed (be careful ...
...seat brackets. Remove 2 torx bolts in the rear hold seat assemble to floor, tilt seat forward to slide front clips out, disconnect power plug and remove seat. You can set seat outside ...
my seat broke at the bracket on the floor Get new seat, try a good auto wrecker first, usually 20 bucks and it's yours.
...any electrical plugs going to the seat pull out drivers door opening Brackets are broken off welds. Remove two rear torx bolts, tilt seat forward to unclip front, pull seat and re-weld
...of those brackets, or as a last resort, have a set fabricated, but I do not know what they look like. THE DEALERSHIP PARTS DEPARTMENT OR THE SALVAGE YARD SHOULD HAVE VECHICLE WITH LOWER SEAT
Question about 2005 Silverado
...use plyers to pull the broken cable to release the seat. If it is a motor you will have to release the motor from the brackets and the seat will slide freely as the motor is the stop and the
Question about 2005 Silverado
On a 2001 Chevrolet Silverado extended cab can you remove the mounting brackets from the rear seats after removing the rear seat? If I am not mistaken, they are welded.
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions