Questions & Answers for: seat belt alarm

...seat belt alarm does not go off after the seat belt is buckled. What is the alarm looking for to turn off? I looked at the receptacle for the buckle and don't see any wires that would give a signal ...

seat belt alarm goes off when belt is buckled I have a 2003 ford explorer sport trac. It has a seat belt alarm that goes off even when I have my seat belt on. how do I fix this? try relapsing the ...

...seat belt alarm (the anoying bell that keeps ringing until you buckle your seatbelt) stopped working. Could this be a blown fuse? My owner's manual is not very descriptive on the subject of fuses, so ...

...Camry seat belt alarm 1987 Toyota Camry when started, a seat belt alarm goes on non-stop and keeps beeping. How can I stop the beeping? make sure that you fasten you seat belts including ...

seat belt alarm fuse in any car at any time. if the seat belt buzzer is on a fuse protected circuit then there would also be other things on the same circuit. if you suspect a blown fuse then look for

...seat belt alarm goes off even when seat belt is buckled, but only if it is buckled after starting the car. If i buckle it first, the alarm does not go off. It seems like the restraint control ...

...make the car alarm,seat belt and back up alarms not work The fuse in the control box. It will be a square one about 25 This will control the alarm module and also the gear shift alarm and seat ...

...posted about what would make car alarms,seat belt and back up alarms not work. It is for a 2003 Buick Rendezvous It will be the control module for the alarm and seat belts Check in the control ...

Seat belt alarm fault Alarm sounds intermittenly when seat belt fastened On an alarm problem this could be one of couple of possibilities, first check the sensor leads comming from the seatbelt assy ...

...seat belt alarm that won't stop? After fastening seat belt, alarm keeps beeping, the dash light goes out fine, but the dinging goes until the car comes to a stop. Starts again when moving forward or ...