Questions & Answers for: Honda CRF 150 F seal 150

150 I have a 2008 Honda crf dirt bike. I road it for a few hours and then had to store it in my garage during a freeze. I pulled it back out and now every time i turn on the fuel it just leaks out the

150 F motorcycle and need to replace the seal in the fork Before you have to spend money on the seal, try this.Get some camera film.You will find some around.Cut off the notched edge,cut one end at 45

...It is leaking some oil as well... U have to pull the motor ,split the case replace the shaft and seal and reassemble.Get a book you'll have to replace it. It will cost a lot of money, time,

...easy to remove.Using a press to install the new ones isn't a good idea either,you will also need a seal and bearing driver so you can hear when they bottom

Bent shifter &shaft now leaks oil. Do I have to split the case to replace seal? no but the problem is not the seal you need to replace the shift shaft and the seal.

...grip is operated. Is the throttle cable kinked or pinched abraded or routed improperly? Is the seal on the manifold still good? Is the manifold tight to the head and carb? Please rate my answer. ...

leaking lots of fuel out the overflow valve. checked the float, still pours out gas.what else can i check Float is either sticking, not sealing or set too high.  These are the only things that ...

...by spraying some Brake Kleen, Contact Cleaner, Starting Fluid etc. around the intake manifold and seals, if the RPM's go up or down significantly then you have a leak that needs to be fixed before ...

...by spraying some Brake Kleen, Contact Cleaner, Starting Fluid etc. around the intake manifold and seals, if the RPM's go up or down significantly then you have a leak that needs to be fixed before ...

...You must always gone the bore when replacing rings. Not only does it allow the rings and bores to seal perfectly, it also removes the burnt on none stick oil coating that is preventing your new ...