Questions & Answers for: Hyundai XG300 scanner verifier lampe

tail lamp replacement how do I replace the bulb for the brake light if there aren't screws on the out side lens, open trunk to get access.

difficulty with replacing fog lamp bulb on 2001 Hyundai XG300 I cannot figure out how to replace the fog lamp bulb (front passenger side). Need some guidance or steps on how to replace. Remove the ...

hyndai xg 2.5 petrol indicators & rear fog wont s hyndai xg 2.5 petrol. indicators & rear fog wont switch off also rear windows wont work .fault not in switchs BEST GUESS... you have a faulty fog lamp

...Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Once you do this and let us know what, if any ...

car missfires but i change the wires and plugs and coil pack but it worse than befor now it sounds like it it is the stater. To get that fixed you have to take it in and get replaced. verify the air ...

2001 Hyundai XG300 Fuse Diagram I have a fuse that is out (dome lights, front door lights). There is no cover on my fuse box under the dash, so I have no diagram to show me the location of which fuse ...

Hyundai grandeur 99 model-can't find relay/module for rear brakes have checked globes, swirch under brake pedal and fuses. What am i missing-is there a relay or module somewhere? thanks Andre WHICH ...

how change headlight on hyundai 2001 xg300 driver side. High beam and yellow work. center bulb only out Remove the head lamp and disconnect the head lamp connector.Remove three 10mm boltsUnscrew the ...

locking the trans in 3rd gear every now and then Check Engine Light? When a 'check engine light' (MIL=Malfunction Indicator Lamp) is turned on, there is a DTC (Diagnostic Trouble Code) ...

Hyundai XG30/300 This car has problem with close loop, work one minute and later the scanner show Open Loop Fault, I changed O2 sensor and Temperature sensor. Does the scanner show any other codes? ...