Questions & Answers for: Fujitsu fi scanner lamp adjustment

Question about fi-4120C Path-Through Scanner

1 Answer

...scanner ON. Open the ADF and press Cover open sensor to see if the lamp lights. If not, the error is caused by the defective lamp. 5. Is the optical unit dirty? 6. Are the cables damaged? 7. Are the ...

Ad

Question about fi-5530C Scanner

1 Answer

E3 error on fujitsu fi-5530C After dismantling, cleaning, and reassembling. Same error still present. Please help You have a rear optical error. check the lamp is lighting.... open the ADF and push in

Ad

Question about fi-4750C Flatbed Scanner

1 Answer

...scanner error When I SCAN A DOCUMENT EITHER THROUGH THE FEED TRAY OR ON THE FLAT BED, i GET AN: FRONT SIDE OPTICAL ALARM ERROR WITH THE FOLLOWUNG IN SENSE KET = 0X4, ASC = 0X680 Try a flatbed scan ...

Question about fi-5750C Flatbed Scanner

1 Answer

Fujitsu fi-4340C changing the bulb My scanners top bulb is burned out. I'm trying to find a way to open up the top to replace the bulb. Any ideas? Open up the ADF ****. Remove Two Silver screws ...

Question about fi-4340C Flatbed Scanner

1 Answer

...scanner. Worked for a while then it showed Front Side Optical Alarm. I tried to clean sheet path, and replaced roller and pickup pad. Still the same error. Does anyone has the similar experiece and ...

Question about fi-5750C Flatbed Scanner

2 Answers

is there a technical manual for Fujitsu FI-5750C Scanner that shows details of replacing parts e.g. lamps, glass etc? http://www.fujitsu.com/downloads/IMAGE/manual/p3pc-e737-02en.pdf ...

Question about fi-5750C Flatbed Scanner

1 Answer

...5750c scanner Hi,The front lamp assy replacement procedures involve technical expertise. Hence, you are recommended to get it done by a certified Fujitsu technician.Thanks & ...

Question about fi-5750C Flatbed Scanner

1 Answer

lamp, heater, CCD, or inverter- Connector disconnectedDoes the same symptom occur after turning OFF and ON the scanner? Check the scanner.Is the White sheet guide (glass) in the FB cover dirty? Remove

Question about fi-5750C Flatbed Scanner

1 Answer

how many lamps are in fujitsu 5750c scanner? how can i replace them? Hi Albert,There are two CCD lamps inside Fujitsu fi-5750c Duplex scanner.One is ADF Front and the other is ADF Back.To replace them

Question about fi-4750C Flatbed Scanner

1 Answer

lamp ON? Are the cables damaged? Are the connectors connected properly? Disconnect the SCSI cable and turn the scanner ON. Open the ADF and press ADF cover open sensor as shown below to see if the ADF

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...