Questions & Answers for: scanner lamp adjustment Office Equipment & Supplies

Question about CanoScan 4200F Flatbed Scanner

1 Answer

lamp switching off at all unless you unplugged your scanner which would undoubtedtly shorten your bulb life. It may be a better idea to play about with the 'lamp off' key number until it just stays on

Ad

...scanner Lamp on Kyocera FS-1118MFP Unit poers up without error, but any scan or copy generates 3200 error and Lamp doesn't light up at any stage. this error belogs to Exposure lamp problem ? cause of ...

Ad

Question about CanoScan 5000F Flatbed Scanner

1 Answer

...lamp problem. when acquiring from scanner it does not complete and gives reasons as bulb heating or object out of place etc. I checked scanner in control panel and it passes tests. I have removed all ...

Question about CanoScan 5000F Flatbed Scanner

1 Answer

...lamp or inverter pcb if needed; replace scanner board or engine board 1. defective exposure lamp or inverter board 2. incorrect shading position 3. poor contact on connector terminals 4. defective ...

Question about CanoScan 5000F Flatbed Scanner

1 Answer

...lamp on low temperature.) Scanner driver will be closed. Code: 2,178,0" I took the scanner (with the installation disc) to the Tech Guys at PC World but they said they couldn't run it because it was ...

Question about KM-1815 All-In-One Laser Printer

1 Answer

...scanner board (KP-5063) and check for correct operation Defective exposure lamp or inverter board. Replace the exposure lamp or inverter board. Incorrect shading position. Adjust the position of the ...

...Scanner Lamp Regulator Malfunction SC199 DF Scanning Finish Error SC120 Scanner Home Position Error 1 SC201: Polygon Motor Error HP Sensor Abnormal-Stays Off SC220 Laser Synchronization Detection ...

...on Check that the copy lamp is lighting ,if not check the lamp cable and lamp itself and replace. Check the scanner motor and the rail then pulleys and adjust.Be careful while handling brittle

...add funtion) adjust/replace cleaning bladereplace scanner lampTry this when zed black copy came outcheck scanner lamp is workingcheck developing unit connection and contactscheck drum earthing ...

Question about fi-5750C Flatbed Scanner

1 Answer

lamp, heater, CCD, or inverter- Connector disconnectedDoes the same symptom occur after turning OFF and ON the scanner? Check the scanner.Is the White sheet guide (glass) in the FB cover dirty? Remove

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...