Question about Konica Minolta Office Equipment & Supplies
lamp uses a HV transformer what is the best way to test this area? Also what else could be the problem? Any help would be greatly appreciated. To you need a mechanical adjustment. A. Adjustment of the
...is just not in a cold environment. Then in order replace: Scanner Unit (contains the scanner lamp) Engine Control Board Image Processor Board Good Luck and Thank You for using Fixya. ...
...scanner error" and line 2 "lamp error". I hve no idea what it means or how to resolve. I cannot find any discussion in user manuals. check this site for service manual Service manuals electronic ...
...if it is the scanner lamp its located under the glass. And you replace the whole module not just the lamp, or is it the fuser lamp, you just replace the whole fuser section which is the Hot
Question about Bizhub 500 Copier/scanner/printer/fax Network Finisher Stapler
how do l adjust ATDC gain on bizhub 500 You cannot manually adjust the ATDC gain in bizhub 500. Replace the developer and execute TCR sensor adjustment in service mode.
lamp error Displays scanner lamp error replace th scanner lamp under the big glass
...a problem with the scanner lamp or the Scanner reader that the CCD the black device under the big glass that views the document to be copied. Exposure lamp is what high lights the original
Question about Minolta DI1610P Printer, Copier, Scanner, 16 ppm, 250-sheet standard paper drawer, USB (DI-1610P, DI...
c650 konica minolta1610f with service code c650 scanner home position code. Check the scanner located under the big glass. the scanner also has the exposure lamp. the bright light.
Question about Minolta DI1610P Printer, Copier, Scanner, 16 ppm, 250-sheet standard paper drawer, USB (DI-1610P, DI...
...A4 copy but it just made s black inked copy. C14A3 means IR fluorescent lamp fault. Check the Exposure Lamp (LA2) . The Scanner Exposure Lamp fails to turn ON. Test the voltage supply & the
...scanner, could have possible come off its rails or if you're lucky, If you cleaned the optics and pushed the exposure lamp all the way to the left, you triggered the emergency sensor, as simple as ...
Usually answered in minutes!
1,023 Questions
924 Questions
417 Questions
321 Questions
302 Questions