Questions & Answers for: Canon CanoScan scanner lamp

scanner mod 4200f the lamp takes 2.5 - 3 minute to warm up. isn't this too long? I have one at home and one at work, it's normal for this scanner. Hello, i have changed 2 registry keys. Now my scanner

...scanner came uip withan error message that read, remove protective film sheet or lamp is too cold. It has worked fine for a year and I didn't move anything. I tried re-installing the drivers with no ...

...scanner. The lamp under the glass should immediately light up when power is connected. Did it do that? If so, then that lamp is ok. The lamp that is inside the scanner lid (use when scanning film) ...

lamp switching off at all unless you unplugged your scanner which would undoubtedtly shorten your bulb life. It may be a better idea to play about with the 'lamp off' key number until it just stays on

...lamp problem. when acquiring from scanner it does not complete and gives reasons as bulb heating or object out of place etc. I checked scanner in control panel and it passes tests. I have removed all ...

...scanner. when starts the lamp is flashing aand the scanner make a noise like "crcrcrcrcrcrrrrrrr..." can yoy help me to fix the problem thank you sell it to me ... ...

how do i open the scanner to change the lamp? This is a very nice scanner - however, I think you will find it cheaper (and much easier) to buy a new one and forget about trying to repair it.

Image scanned is black. look to see if the scanning lamp come on when you scan a document. if it doesn't, then either the lamp is blown or you need the scanner main board

Scan is black If the scanner light does not move or does not light up then the problem could be a broken belt drive ob the scanner lamp or the scanner lamp is faulty.

Lamp shuts down during warm up cycle! Scanner works fine in normal mode but when in transparency mode the lamp turns of after about 7% through tha warm up cycle and then stops. I have reinstalled ...