Questions & Answers for: Epson scanner lamp

scanner lamp. ? Power is turned on without unlocking the scanner. * Unlock the CR. ? The scanner carriage is interfering with any other part. * Remove the obstacle. * Replace the scanner carriage unit

...lamp assembly. Have had the scanner for three to four years. Any suggestions would be greatly appreciated. Thanks for your time. Julie Hi FYI, A lamp Circuit board and assembly would cost around 80% ...

...scanner and have noticed that on the bottom bed scan carrage ther are two lamp, but only the one nearest to the front of the machine appears to operate, do you know if both of these lamps come on or ...

...scanner is not working. Is this likely to be the actual lamp / florescent tube and if so is it something I can replace myself. Thanks George. If the lamp is not working their are two main ...

epson expression 1640 xl scanner need to know replacement lamp number and where to buy You can order the lamp from website below: Parts for the Epson Expression

...scanner warms up and scans. If I select film (35mm) and preview, the bulb goes out, does not warm up and attempts to scan. I reinstalled SW and updated driver, but no luck. There are two lamps with ...

...unplugged and reinstalled and still get the same result. it sounds like the scanner lamp is not coming on, the scanner shipping lock is still set, or the scanner unit is not coming to the home ...

...scanner lamp will not stop. After proccesing the motor stop but all off the lamp blink. GAN GIMN YUA...saya punya epson tx111..kendalanya di scaner nya...scaner nya g jalan..jadi ke frinter general ...

...scanner lamp which did not go the entire way across the page. If you check everything I have just mentioned and do not find any problems then the only cause could be bad memory on the scanner board. ...

How do I replace fluorescent lamp. Scanner not working. Hi,You cannot actually change the lamp for the scanner. Better get a new one instead. Have a nice day!