...SATA (first Gen) then you have to add a jumper (Seagate has the jumper setting on the drive but sometimes supplies no jumper i.e. you have to have your own). First thing you turn off the power then ...
Question about MaxLine Plus II 7Y250MO 250 GB SATA Hard Drive
...jumper settings on 250gb Maxline Plus II SATA I have two Maxtor Maxline Plus II 250gb SATA HDD drives that I wish to use together in a system, neither of them is marked with jumper settings of any ...
Question about Caviar 500GB Internal SATA Hard Drive
...jumper at all thanks The SATA Drives do not need jumpers to set primary and secondary drive positions. Each sata drive gets it's own connection to the motherboard. Check you motherboard diagram, and ...
...jumper at all on sata device You don't need it. On SATA hard drives, jumper settings enable or disable enterprise-level features. SATA hard drives are factory set for workstation/desktop use. For ...
Question about 250GB Hitachi 2.5" SATA Hard Disk Drive (5400rpm, 8MB cache) Hard Drive
...jumper setting to run my hitachi 250 gb sata laptop hdd as a slave ? There should be, look on the rear of the drive, close to the SATA and power connectors, you should see the jumper connections as ...
jumper your 3.0 Gbit/sec SATA drive to the slower speed of 1.5 Gbit/sec for the system to recognize it properly. For further information on changing the jumper setting to slow down your SATA drive'
Question about 2.5 Hdd 250gb 5400rpm Sata Mobile||156|hard-drives|2.5 Inch|hdd|2.5|sata|0.11|mhz2250... SATA Hard Drive
set jumper to either slave or cable driven per apple....how to do this? At the back edge of the hard drive next to the data and power connectors the is a jumper position for configuring the hard drive
my sata hard drive and do I need a jumper on sata hard drive and what setting would the jumper go on A sata drive doesn't need jumpers. The jumpers were only required when 2 drives used the same cable
...jumper settings, but SATA do not require any. The diagram of the setting is drawn on the hard disk itself below the serial number etc. For SATA, look on the motherboard for the SATA ports. Each port ...
Question about WD Scorpio Blue WD2500BEVT - hard drive - 50 GB - SATA-300 SATA II
...wd2500bevt slave jumper settings Which jumper setting is for slave SATA drive position is determined by the plug on the motherboard, not a jumper. Jumper settings are for PATA drives (much
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions