clutch Problems with my rx7 When i was driving my 1984 mazda rx7 GS I was slowing down and the clutch pedal went to the floor and would not come back up and the car refused to move and i have no clue ...
...rx7 1989, when aclerate it jst revs out and doesnt move slipping I am assuming it's a standard. Your clutch and pressure plate are slipping. Check to see if the clutch can be adjusted , if not they ...
clutch located on a mazda rx7 1986? i need too change the clutch since the clutch went out? The clutch assembly is located inside the 'bell-housing' which is the flared forward section of the gearbox.
My rx7 Gxl is making a loud clanking noise when I let go of the clutch while shifting and pressing the gas throw-out bearing or diaphram going bad. is it hard to put in gear?
how do i change the clutch on a 1983 mazda rx7 with great difficulty ,its a dirty hard backbreaking job ,now is it front wheel drive or rear wheel drive
...rx7's clutch went so loose that it actually stuck to the floor and the car died. it started drove awhile then repeated the problem. now it won't start; seems like it has no compression Fixing the ...
clutch plate on 1992 mazda rx7 You will have to drop the transmission. Inspect the pressure plate for excessive wear and stretched springs when you remove it. Replace your throwout bearing at the same
is there a clutch safty switch on my 1988 rx7 look right above the clutch pedal, it should have one.
RX7 won't start, just clicks Won't Start. Turn the key, push clutch in and it just clicks. All the idiot lights come on check battery and connection.could be starter try to tap the starter
How do I remove the clutch pilot bearing in my 1990 Mazda RX7 Check with your local parts store to see if they loan tools and have the removal tool.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions