...measure the resistance from the antenna connector center conductor of the cable to ground using the Rx1 setting on an Ohmmeter, you should have infinite resistance (no meter deflection). If you do ...
...all the wires going to the small terminals (primary) on your coil. Using a good ohmmeter on Rx1 setting, test the resistance between the two small terminals. You should read somewhere between ...
...RX1 scale and touch both stator pins with both leads, reading should be 0.1to0.2 ohms. Then set the meter to volts AC and fire up the bike and set the throttle for 2,000RPM meter should read 32 to 40 ...
idle air control motor. If power from terminal 31 is disrupted by a (blown fuse, etc.) always turn the key OFF wait 10 seconds then turn the key ON to reset the motor to the default position. Test the
Question about 2008 FLHTCU Ultra Classic Electra Glide
...Rx1 setting, test the resistance between the two small terminals on each segment if the coil. You should read somewhere between 2 and 3 ohms. If you read more, the coil is bad. However, before you do ...
Usually answered in minutes!
980 Questions
644 Questions
497 Questions
317 Questions
274 Questions