brake line replacement replacing all brake lines&hoses due to rust. need to know fitting sizes to begin this project without dismantling everthing, (only car).ex.:brake bleeder screw supposedly 3/8" ...
...rusted out. the area is about two or three inches to the right of the drain screw. It's a fairly good leak, do i have to raise the engine up in order to replace it? yes the engine has to be raised to ...
1999 mercury sable My heater and air conditioner does not work. My antifreeze reservoier keeps filling up with rust. what could be causing this. I had it flushed twice but keeps returning the rust ...
rear brake drum removal 1992 mercury tracer there are 2 screws in the drum do they need removed Yes. and than the drum will come off. You will find that it will not move at first so take a hammer and ...
my blinkers and breaks lights dont work what should i do i have check the fuse and bulbs Check to see if the light sockets have a good ground. If you don't know you can always clip into the ground ...
how to remove the door panel on 1991 mercure cougar. I need to replace window motors. DOOR TRIM PANEL 1989-92 Models (see Figure 8 - click over pic for zoom) Remove window regulator switch housing. ...
trying to bleed brakes on a 93 cougar, but cannot loosen bleeder on both right side. I have tried penetrating oil and heating up bleeders. it is at the point of stripping. how can I remove them with ...
Question about 1993 Grand Marquis
1996 Mercury Grand Marquis wipers don't work. I changed the motor and the fuse isn't blown 1996 Mercury Grand Marquis wipers don't work. I changed the motor and the fuse isn't ...
Question about 2005 Grand Marquis
I have a clicking noise in the right rear of my 2005 Mercury Grand Marquis. It sounds like it clicks in time with the tire rotation would the abs speed sensor make a clicking noise There are brakes ...
Question about 2000 Grand Marquis
...screw driver to wedge or the pliers to hold onto the bolt heads for removal and assembly also use antiseize lube on the threads have fun this is a pain because of the rusted bolts but just be patient ...
Usually answered in minutes!
1,305 Questions
689 Questions
627 Questions
646 Questions
630 Questions