Questions & Answers for: Chrysler rusted screw

...the wires off and unscrewed a few screws and replaced it. On the Olds, the resistor wires were rusted and separated. The replacement works fine. I THINK it was about $30.00 for the

Front Window Wipers will not move This morning I went to turn on the window wipers and they attempted to move but will not. There was an ice storm yesterday, so I thought they might be frozen. I ...

...the plastic by the radiator. "CAUTION: DO NOT UNBOLT THE RADIATOR." If any of the screws are rusted into place put some penetrating oil them to help loosen them up. PLEASE DON'T FORGET TO

'97 sebring w/ rusted brake lines need replacing I was actually just wondering how much it should cost to have a mechanic replace the brake lines in my '97 Chrysler Sebring JX convertible. They're ...

high pitched squeal when braking, but plenty of pad Driver's side rear disc, on the inside of the hub, looks like its had constatnt contact with the parking brake. Other side has no contact at all. ...

spare tire will not drop down when cable is cranked down The cable is likely frozen due to rust/corrosion. Sometimes you can get under and douse it with WD-40 and it will free up. Thanks for using ...

...screw, then the rotor is just rusted on. It just needs a little persuasion to come off. A good way to break it free from rust is to hit it with a hammer. If you need to re-use the rotor, make sure to ...

how do I fix my tilt steering wheel that is stuck in the down position. The tilt lever will not engage to go up or down. Follow these steps: 1. Disconnect the battery by removing the negative wire-you

...rusted springs in the motor > 2 options , dismantel the fan clean and lubricate the coals, or replace the fan 50$ on Ebay. Fan enclosure very difficult to get out (third screw between ...

...screw in the piston if you have an internal parking brake,open the bleeder also to make it easier Does caliper not come off because the mounting hardware is rusted, or is it simply stuck (seized in ...