Questions & Answers for: rust microwave door

...microwave is only about 3 or 4 years old. Wish I'd kept the receipt so I'd know. Many thanks. just use sand paper to clean the rust then use some high temperature paint (sold in tins) eg spray paint ...

door rusted very badly. Can I paint it? Yes you can paint it.. Begin by removing the rust with either a wire brush or a thick paste product called naval jelly. Then prime the area and finally paint it

Rust in the ceiling, corners of microwave; also on the door There is rust on the corners and the ceiling of the interior of the oven. I read someone recommend a microwave interior paint (part 277) ...

...microwave has a small rust mark on the door & the inside rim. When I open the microwave door the marks are on the trim near the hinges. The marks are not actually on the inside the microwave. ...

...rust discoloration on glass part of door. Took door off, removed handle. Is there a way to access the inner surface to rid grid of rust? It would appear that no one knows how tofix this problem. I ...

...rust in my microwave - is it now safe to use Too generic...Did you use the high-temp appliance enamel recommended, or a spray...or worse? Was the rust inside where it can contact food through the ...

rust like streaks inside my Whirlpool Microwave Door Panel. It is unsigthly. How do I get rid of the rust-like streaks? Disassembling the door is a major pain and the streaks will likely only be faded

rust inside the microwave, ist it still safe to use if the unit starts to spark then you can buy microwave paint but if it goes through the door or the base then a professonal repair is best,clean the

...microwave is developing some rust spots along the very sharp edge of the " floor " where the door shuts on it. Could be grime. If that is rust then maybe there is too much humidity at the location of ...

...MICROWAVE AND IT HAS RUST INSIDE THE DOOR ON THE METAL SCREEN, HOW CAN i REMOVE THE RUST? Have to replace the inner door, some of those are available as a complete door assembly. Unit must come down ...