...runs fine with choke on or off until you give it gas. Try changing the gas. Pour old gas out and put new gas in. Make sure the fuel mixture is correct. Check the fuel lines for cracks/breaks. If they ...
...runs for a couple of seconds and throws the reset button again. The unit 1 1/2 years old and I've always had to rorate the motor by its fan to get it going. one of two things, either you have a bad ...
Question about 33cc 14-Inch Bar 1.9 HP Gas Powered Chain Saw #DCS34
...dies when I power up. Seems like no fuel. Have had trouble getting it started especially when warm. Took it in to a repair shop and they cleaned the carburetor and it looks like the carb adjustment ...
Question about 33cc 14-Inch Bar 1.9 HP Gas Powered Chain Saw #DCS34
Chainsaw difficult & sometimes impossible to start. Plug looks OK. 5 years old, just occasional use. Yes. Whether storing your saw for a week or a month, a quality fuel stabilizer adds life to ...
...runs for 2 to 3 seconds and pops breaker. It is a variable speed grinder does it run freely?as in not seem to be lugging from bad bearings in the motor shaft,then check the speed control board for a ...
I have a makita jn1601 nibbler and I'm trying to change the punch. How do I do this? Removing or installing the punch and die Always replace the punch and die as a set. To remove the punch and die
Question about Factory-Reconditioned Cordless 1/2" 14.4V Drill 6333DWBE
i have 2 older batteries and after charging them they would die after about one mintue. i thought the batteries being old that they were no good. i just bought a new battery and after fully charging i
Question about DCS6401 20 20",64cc Chainsaw 2 Cycle
...runs well untill it gets warm again. outside temp now is about 5-10 degrees F I've had similar on a Husky which went on to break a piston ring. Turned out to be a combination of 2 things. The exhaust ...
Question about DCS6401 20 20",64cc Chainsaw 2 Cycle
...Runs for 15 seconds, shuts off. after about 15 seconds it will restart run for a bit and shut off. This problem began after I used it for wet extraction. Lux vaccum cleaner D775 Classic shuts off ...
Trouble shooting makita 4300 generator Trying to get my generator to start. I'm bypassing the carb at the moment, I checked for spark, compression is 95 psi and I'm squinting a little gas directly ...
Usually answered in minutes!
83 Questions
20 Questions
16 Questions
10 Questions