Questions & Answers for: Jaguar X-Type rubber handle sticky

Engine engine has a knock in it,(sounds like it is comming from the top side) it calms down after running for a while but is very noticable. Engine only has 77,000 km's on it. no engine lights come on

...rubber seal is sticking out. Mine does this and sometimes I need to push against the door while lifting the handle to open it. Use a spray lubricant like WD-40 on the latching mechanism in the door. ...

1994 Jag xj6 car door will not open from the outside When I lift the door handle from the outside nothing happens. It feels floppy no tension. However I can open the door from the inside using the the

...rubber dust sheild behind it. Then you clean and lubricate it. When all is moving freely, the arm should spring back against a hard stop each time the cable is pulled. There is an adjustment on the ...

my tata magic doesnot shift to 2nd gear in fact my tata magic doesnot shift to2ndrd gear in fact gear stuck on 2nd Could be gearbox failure, a sticky gear linkage, or a shot clutch get under the car ...

Thank you for your response , been going crazy here...got panel off enough to put hand in but don't know where to pull to unlock door. Jaguar 2000-06 - Locks & Lock Systems Power Door Locks - ...

how to remove the rubber damper on the bottom of the caliper on a 03 jaguar x type. This is on the rear brakes, To remove the bushing you will need to remove the slide, this is the metal part that the

i noticed a burning rubber smell from the drivers side front of the car today, i had only driven a few miles and its the first time ive smelt this, however possibley connected? or not? for the last ...

my a/c only gets cold when im going over 50 for more than 10 than i feel it getting cold? Any suggestion on what is costing this? Sounds like your a/c is low on gas, get it checked and recharged after

What would cause my surpintine belt to snap and leave a very black sticky mess behind a few --check the pulleys one may be seized or on its way --belt stretched over time and slipping on pulleys ...