...on to the floor remove spring retainer ruber door boot remove the rubber.looking for the clamp loose it put the door boot back in the tub(drum)tie the clamp go revert the procedure(take out)good ...
Question about Energy Star WCVH6260F Front Load Washer
...rubber door seal yourself if you are logically minded and are handy with tools. Isolate the washer from the mains supply. Remove the top fixing screws at the back of the washer. Slide the top of the ...
rubber boots at the bottom of the door that just sit and the door seal is supposed to seat into these rubber boots but if you take out the boot you will see that it is misshapen and therefore leaking.
rubber door seal into the washer, stretching the seal. The rubber door seal is formally called a; "front door boot gasket". (image of washer type linked below) http://di1.shopping.com/images1/pi/e8/78
RUBBER DOOR BOOT (called a bellow) for small articles of clothing (like socks and underwear) that may have gotten lodged in behind the rubber. Pull the rubber back where it meets the wash tub and look
...bottom access panel and door hole. make sure to pull clothes gently straight out of the unit and not at an angle across the rubber boot, it tears really easy.. hope this helps, best of luck, ...
Question about Energy Star WCVH6260F Front Load Washer
...rubber gasket inside the door is torn. If the tear is small, try using silicon glue to repair it--clean the surface of the boot and apply the glue. Let dry for 24 hours before using the machine. If ...
...people. Door side of rubber gasket is easy in comparison with rubber tabs inserted into slots and working the gasket into a groove. Hose clamp at bottom of rubber gasket to connect drain hose. ...
...it over. Hi, Open the door, and with a flashlight carefully inspect the rubber boot between door and tub pulling it back. You are looking for a cut or tear at the bottom of the boot. Hope this
Question about WBVH6240F Front Load Washer
...door. once this is off just pull the rubber away from the front, the next bit is a bit tricky. you may have to take the top off the washer for the next part. you will have to reach down and ...
Usually answered in minutes!
992 Questions
874 Questions
371 Questions
398 Questions
323 Questions