Questions & Answers for: Pontiac Grand Prix rubber becomes sticky

rubber mount, which over time becomes flattened, cracked and worn...allowing the motor to move too much. Put the bolt back into the mount, and tighten the nut. You'll be using it as a handle to torque

Ad

Question about 2002 Grand Prix

2 Answers

...becomes harder. i would start by having the trany oil flushed out, ive had great luck with the BG trany flush machine, this is like a transfussion, it removes 100% of the oil fluid. theres a cleaner ...

Ad

my 2004 grand prix runs hot one day then all of a sudden its fine for the next 2 months sounds like a sticky engine thermostat try swoping it for a new one, trying to test it is not worth the time

Question about 2004 Grand Prix

1 Answer

...becomes sticky when it is hot, such as after reaching normal operating temperature. Carefully remove the valve from the throttle body, paying close attention to where the rubber o-ring is...it may ...

Question about 1995 Grand Prix

2 Answers

...becomes sticky in hot weather HI, this is usually caused from the build up of products like armour-all and cleaners that don't wipe off cleanly. Try cleaning it with a good glass cleaner they usually ...

becomes soaked with water. It occurs predominately on the passenger side and floods all the way to the backseat. I know this problems is not any way associated with the air conditioner. A fellow grand

...create voltage..........then as the belt warms up, the fibres expand and the ruber becomes sticky and it stops slipping....therefore the problem is always worse when it is cold....... I hope this ...

Question about 2005 Grand Prix

1 Answer

low brake fluid message on dic 2005 pontaic gp checked brake fluid it is not low . what is the problem add a little fluid anyway, or the float switch is sticky

Question about 1998 Grand Prix

1 Answer

...becomes less sticky and allows the valve to open when it should...hence the problem "disappearing" after you've driven a while. Remove the wiring harness from the valve and remove the mounting ...

Question about 1998 Grand Prix

1 Answer

rubber pipe attached with hose clips. The high pressure feed pipe will connect to the steering pump).Get a large container, which must be at least four times the capacity of the replacement fluid, You

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...