rattling noise top end of engine 01 roadking classic with a pumped up motor just changed oil to screaming eagle synthetic is it the cause???? The first thing I would do is change the oil and clean the
Question about 2005 FXD - FXDI Dyna Super Glide
Engine backfiring it is a EFI model with22k miles and V&H pipes Just recently put gas additive in it (SEAFOAM) An intake valve clearance may be too tight, a weak/broken valve spring, or just ...
2005 HD Sportster - How do you get the rubber clip 2005 HD Sportster - Tryin got put the battery cover back on but the top left rubber clip popped out of the hole. How do you get the rubber clip on ...
...rubber becomes brittle and loses it's sealing ability. If this is what you're talking about, it won't hurt anything. Just ugly looking. If this does not answer your question, check you translation or ...
Question about 2006 XL 1200 C Sportster Custom
jedboss1 my 2005 sportster only runs with choke on remove and clean the carb. you could have a plugged jet or sticky float valve
Question about 2006 XL 1200 L Sporster Low
...line off the bottom of the tank has become detached at the other end. The other end is larger soft rubber tubing, that looks like it originally went past the batter housing. Where does it need to be ...
my starter switch stayed engaged for about 10 min now clicks but wont turn over bike Battery is dead and or starter is dead or main wire is burnt into or two of these. Find the sticky too
my rear brakes lock up get hot I would start off by taking calliper off and giving it a good clean with brake cleaner. I would think the pistons in calliper are dirty and sticky. Hope this helps
Question about 2005 FXST - FXSTI Softail standard
...rubber diaphragm that sealed the cover if that gasket cracked or was damaged the pump may not function correctly maybe a dribble instead of a stream , it would cause the engine to stumble especially ...
...rubber cover loosen the jam nut and run the adjuster all the way in, next slide the round cable end called the ferrule into the hole in the wheel, next grab the cable housing and spring lift up and ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions