...sticky it was(did not want to come out easy and therefor especially not back off) decided to replace calliper (expensive but life time warranty) to keep life simple. I like the design, very easy to ...
...hose pops off 1998 chevy s-10 pick-up check to make sure squirters are not pluged then replace the rubber hose,sometimes over a period of time the hose will become hard/dry and not stay ...
...rubber grommet seal and disconnect wire at connector, careful that other end does not pull back in, i tie string on it before disconnecting so i cant loose connector inside. then close hatch and ...
...- I have 1994 Chev Silverado clutch slave cylinder leak problem. You will have to replace the rubber and the piston like mechanism to get this done. If you found an assembly replacement for the ...
...rubber as it ages becomes stiffer & may develop cracks, but heat makes it a bit more pliable, not my personal opinion, but observed whenever my father(military Doctor/Surgeon ) would be posted to ...
...sticky due to the friction they produce when worn. if you can, remove the door panel and the inner splash guard(plastic liner) and roll the window down, then when rolling back up, apply pressure ...
when i start my 2001 Chevy Malibu in the morning it tick for a while until it warms up. is this normal and if not how do i fix it Suspect valve tappets that are adjusted by oil pressure from the ...
...rubber bumper that stops the gas pedal from coming up too far, it gets sticky and holds the pedal, you have to stomp on it to free it and then it is ok for a while, I sprayed mine with wd40 a few ...
...silver ado it has another arm on otherside wich is attached to the driver side as we'll it has a rubber grommet that broke off and is not attached anymore. Make sure screw on other wiper didn't ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions
