Questions & Answers for: Lexmark rubber become sticky

...landfill trap. Many thanks!! If you have used a fair amount of low-cost paper since it was new, the rubber transport rollers may be clogged with paper fiber which causes the rollers to slip. I don't ...

...the tyres with a damp cloth to remove any paper dust, it also gives a bit more stickiness to the rubber (make sure the machine is unplugged and that the cloth isn't dripping wet, just

...sticky, Clean the area until all ink is removed, you will use many cotton balls, continue until clean. Check the carrier parked area. You will note 2 rubber boots, 1 for each ink cartridge, make ...

...rubber rollers, they become less tacky and therefore unable to grab a single sheet of paper. To prevent and/or cure this type of paper feed problem, these rubber rollers should be cleaned. Unplug the ...

...rubber bar, also you will notice the printer cartridges moving to the side as you open the lid of that printer. If the cartridges did not move back to the one side, it means that the guidance rod is ...

cartridge error 50c The most usual solution of this error is to change the catridges ( both ). But it also can't work in some cases. In that case try to locate the protective tape on the catridges. If

...rubber rollers, they become less tacky and therefore unable to grab a single sheet of paper. To prevent and/or cure this type of paper feed problem, these rubber rollers should be cleaned. Unplug the ...

...for? Bonds a variety of porous and non-porous surfaces Metals Wood China Rubber Leather (test first as some leather may become hardened or discoloured) Some plasticsI or have to purchase the ...

...sticky head primer. The print heads eventually get stuck to the rubber primer stoppers to the right or left of your printers hidden area. Open the door to your printer the same as you would when ...

...rubber rollers, they become less tacky and therefore unable to grab a single sheet of paper. To prevent and/or cure this type of paper feed problem, these rubber rollers should be cleaned. Unplug the ...