...sticky it was(did not want to come out easy and therefor especially not back off) decided to replace calliper (expensive but life time warranty) to keep life simple. I like the design, very easy to ...
...hose pops off 1998 chevy s-10 pick-up check to make sure squirters are not pluged then replace the rubber hose,sometimes over a period of time the hose will become hard/dry and not stay ...
...rubber grommet seal and disconnect wire at connector, careful that other end does not pull back in, i tie string on it before disconnecting so i cant loose connector inside. then close hatch and ...
...- I have 1994 Chev Silverado clutch slave cylinder leak problem. You will have to replace the rubber and the piston like mechanism to get this done. If you found an assembly replacement for the ...
sticky when cold. Warmth from the engine helps the grease loose its viscosity:and the electromagnet pull is sufficient to overcome this dried up grease such that it responds as it normally should.----
...become worn and get sticky due to the friction they produce when worn. if you can, remove the door panel and the inner splash guard(plastic liner) and roll the window down, then when rolling back up, ...
...become sticky after long use and are slow to close the valve adjustment to zero which prevents clicking. Be sure to have a fresh oil change/filter and use 'high mileage' oil which will tend to clean ...
...rubber bumper that stops the gas pedal from coming up too far, it gets sticky and holds the pedal, you have to stomp on it to free it and then it is ok for a while, I sprayed mine with wd40 a few ...
...to the driver side as we'll it has a rubber grommet that broke off and is not attached anymore. Make sure screw on other wiper didn't become loose look under black rubber cap on wiper mount good ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions