Questions & Answers for: rpm drop

...rpm should drop back to idol speed. Well it doesnt. The idol will drop to about 1,500rpm and sit there, after about 3 - 5 seconds it will then drop to idol rpm. Another factor i found with this ...

Ad

...drop rpm under 1K. Will run (under 55 mph) but once i make a stop rpm drops under 1k. most older cars were designed to run between 600 to 800 rpm so its not an issue, if the aircon is on it should ...

Ad

...rpm drop to zero when I reduce speeds or idle at intersections. After this, it is impossible to restart the engine until it has been allowed to 'rest' for sometime. Edwin from Kenya This may been an ...

...rpm continue to drop badly. What's the problem? Is it with the servo? or with my automatic transmission? Please help.... Thanx indicates that an over rpm sensor is activating run the fault codes to ...

...on steep roads also because as I accelerate speed the rpm continue to drop badly. What's the problem? Is it with the servo? or with my automatic transmission? Please help.... Thanx its your ...

'99 silverado 5.3 engin will not idle runs at 2500 rpm and drops down to 1000 rpm the back up to 2500 rpm ------------------------- '99 silverado 5.3 engin will not idle runs at 2500 rpm ...

Question about Domino Engineering Garage keyless entry system DNSC-GD1

1 Answer

...engines rpm drop for a wille and after start up. its normal for rpm to be up when engine is cold,then drop after engine is warm.If to low it could be you throttle posistion sensor giving you the ...

Question about Domino Engineering Garage keyless entry system DNSC-GD1

1 Answer

...dropping ac compressor will drop the rpm by about 350 -450 rpm and this is compensated for by the CPU which increases the fuel setting to maintain constant rpm. Run fault codes if there is a ...

RPM dropping. it must not drop ,in fact most cars A/C on raise idle speeds by 200 or so. is this gas or diesel. im too lazy to look it up. 1.8 the charge lamp did not lie, voltage did drop below 13.3v

Question about 2005 75 1.8

1 Answer

have its own mixture screw. with engine running, slowly back out. Rpm should drop. Slowly screw in. Rpm should increase, then drop. Back out to peak rpm then another 1/3 turn. Do screw for each barrel

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...